OCA=0, CSC=0, PSPD=00, FPR=0, HSP=0, PTS=000, PR=0, PTC=0000, SUSP=0, LS=00, PEC=0, PFSC=0, CCS=0, OCC=0
Port Status and Control Registers
| CCS | Current Connect Status 0 (0): No device present (host mode) or attached (device mode) 1 (1): Device is present (host mode) or attached (device mode) |
| CSC | Connect Change Status 0 (0): No change 1 (1): Connect status has changed |
| PE | Port Enabled/disabled |
| PEC | Port Enable/disable Change 0 (0): No change 1 (1): Port disabled |
| OCA | Over-current active 0 (0): Port not in over-current condition 1 (1): Port currently in over-current condition |
| OCC | Over-Current Change 0 (0): No over-current 1 (1): Over-current detect |
| FPR | Force Port Resume 0 (0): No resume (K-state) detected/driven on port 1 (1): Resume detected/driven on port |
| SUSP | Suspend 0 (0): Port not in suspend state 1 (1): Port in suspend state |
| PR | Port Reset 0 (0): Port is not in reset 1 (1): Port is in reset |
| HSP | High Speed Port. 0 (0): FS or LS 1 (1): HS |
| LS | Line Status 0 (00): SE0 1 (01): J-state 2 (10): K-state 3 (11): Undefined |
| PP | Port Power |
| PO | Port Owner |
| PIC | Port Indicator Control |
| PTC | Port Test Control 0 (0000): Not enabled 1 (0001): J_STATE 2 (0010): K_STATE 3 (0011): SE0_NAK 4 (0100): Packet 5 (0101): FORCE_ENABLE_HS 6 (0110): FORCE_ENABLE_FS 7 (0111): FORCE_ENABLE_LS |
| WKCN | Wake on Connect enable |
| WKDS | Wake on Disconnect enable |
| WKOC | Wake on Over-Current enable |
| PHCD | PHY low power suspend |
| PFSC | Port force Full-Speed Connect 0 (0): Allow the port to identify itself as high speed 1 (1): Force the port to only connect at full speed |
| PTS2 | Port Transceiver Select [2] |
| PSPD | Port Speed 0 (00): Full speed 1 (01): Low speed 2 (10): High speed 3 (11): Undefined |
| PTS | Port Transceiver Select [1:0] 0 (000): Use UTMI transceiver interface. |